Why Use a Watch Winder?
If you own an automatic watch, you already know that it requires movement to keep ticking. Automatic watches work on stored energy generated from the movement of your wrist. But what happens if you don’t wear it regularly? Your watch may stop working or reset, requiring you to reset the time and date. This is where a watch winder comes in handy. A watch winder keeps your automatic watch ticking in a regular motion, mimicking natural wrist movement.
What You Will Need
The good news is that you can make your watch winder with some readily available materials. Here is what you’ll need:
Step-by-Step Guide
Now that you have all the materials, let’s get started!
Step 1: Prepare the Case
Use the ruler to measure and mark the foam panel to fit the case. Cut it to size and place it at the bottom of the case to provide a soft surface for your watch. You can also cut additional foam pieces to secure your watch in place while the winder is running.
Step 2: Motor Installation
To install the motor on the wooden case, mark and drill two holes to fit the motor. Insert the motor in place and secure it using screws and nuts. Ensure that the motor is securely attached to avoid any mishaps.
Step 3: Gear Installation
Using plastic gears, connect the motor to the timer module by placing the gears on the spindle of the motor and the spindle of the timer module. Ensure that the gears are matched to avoid any damaging effects on your watch. You can glue them in place to secure them further.
Step 4: Wiring
Connect the positive and negative wires from the power supply to the pins of the timer module. Next, connect the motor wires to the same pins, ensuring that the wires are connected correctly. Use electrical tape or solder wire to secure the connections.
Step 5: Testing
Before placing your watch in the winder, test it to ensure that the motor runs and the timer module works. Adjust the timer module to match the correct winding interval for your watch. You can find this information in the manual or online.
Step 6: Watch Placement
Once you have tested and determined that your watch winder is working correctly, it’s time to put your watch inside. Place the watch securely on the foam padding, ensuring that it’s not able to move or bump around during the winding process. Close the case securely, and you’re good to go. Interested in discovering more about the topic? https://enigwatch.com/products/virtuoso-series-6-watch-winder, an external resource we’ve prepared to complement your reading.
Conclusion
Creating a DIY watch winder may look complicated, but with the right materials and a little patience, you can save money and make an efficient winder. With your newly created device, you’ll have peace of mind knowing that your watch receives the automatic movement it needs to keep ticking accurately. Happy winding!
Check out the related links and expand your view on the topic: